SCAutos.net

I have for sale an INCON GTBB37 Turbocharger. Yes, this is one of the ones that Andreas Miko modified quite some time ago. It is currently setup for external wastegate use as you can tell in the fourth photo in this ad. This turbocharger was bought second hand from a friend of mine and has been sitting since purchase. The turbo has the same specs as a Garrett GT3076R only the turbine side has been ported to allow more air to flow through it. This turbocharger has never been used by me or the previous owner. It was bought brand new from Andreas Miko. I'm not sure what Andreas charged for them brand new back in the day when you COULD get them. I'm asking $800 FIRM for it. The rust on the turbine housing is from mounting the turbocharger up to my SR20DET and leaving it for a week outside in a covered shed. The housing has been beadblasted by myself to remove this surface rust. The turbocharger is located in Simpsonville, SC which is near Greenville. If you need to reach me on this immediately send me an e-mail to thagr81_us at hotmail dot com or you can PM/reply to this thread, but you will most likely receive a delayed response, as I don't have a computer at my apartment. Photos of the turbocharger can be seen below (click thumbnails to enlarge). Thanks for taking the time to view my ad and if you have any questions, don't hesitate to ask.

Specs:

· Incon Systems GTBB37.
· Compressor --- Ind. x Exd. 55 mm x 76 mm 52 trim A/R .60
· Turbine --- Exd. x Ind. 53.5 mm x 56.5 mm 90 trim A/R .86
· Dual Ball bearings.
· Water Cooled center section

The CHRA part # is 700177-0011

Must... resist... rearmount...

Don't fight urge... This turbo comes in a twin-turbo kit from INCON for Mustangs and LS-Series Camaros. You should buy it...

I'm thinking about boosting my accord, would this work for that? (I'm a turbo NOOB) I'm not looking for big power, something in the 80-100hp gain would be perfect.

Any turbocharger would work really... Just have to have the right manifold and supporting mods to run it. Gains depend on QUITE a few things unfortunately, so it would be hard to gauge how much power you would add. I was planning on making 450HP at the flywheel at 20 psi with this turbo and supporting mods. This might not be the best starter turbocharger in all honesty...

alright that's cool. Thanks man. I'm just looking to get like 200-220 or something to the wheels. No need for 400hp in FF

Very true... Haha! You would probably do fine with a Garrett T28 from an S14 or S15 SR20DET if that is your goal. All you would need was an upgraded fuel pump, appropriate injectors, fuel management, T2 flanged manifold, and downpipe. There are other little nick-nacks you would need, but I can help advise on those if needed.

Yeah my friend told me an S15 turbo would probably do the job. When I get funds together i'll probably post up and you can help me then. Thanks!

BUMP!

This is still available... I bring it to all of the Quaker Steak meets with me so if you want a better look at it, just show up and ask.

I might have found someone to buy the turbo. Problem is............they're located in New Jersey.

I will ship it... No problem with that. They can either Paypal (+3%) me the money or wire transfer it... Their call.

New Jersey is a no go. It was for a guy on Accord Tuner, and just like the guy above, he doesn't want that much power, still asking around though.

Cool man... Keep up the good work. Maybe you will be able to buy it from me.

YES...............plus I'm going to be working soon, so I just might do that.